All individual V-T2 purchases include: (2) V-T2 ventilators (one for each livewell or baitwell lid), marine fasteners, installation instructions, and warranty per pak. *We recommend (2) V-T2 ventilators for boats with livewells that hold 20 gallons or more. If you have a small livewell that will hold 20 gallons or less of water, and only need to purchase (1) V-T2 ventilator, please contact us directly at 502 747-8052.
V-T2 Black (2 per pack)
V-T2 White ( 2 per pack)
You may also order via the telephone by calling: 502 747-8052
V-T2's installed.
V-T2 Livewell & Baitwell Installation
To install the V-T2's, you will need a hand drill,drill bit and a 3 inch Bi-metal hole saw. The Bi-metal hole saw will easily cut through both fiberglass, composite and aluminum. It is recommended to cut the holes for the V-T2's in the middle of each livewell or baitwell lid directly over the water in the livewell. If you have a single large lid over your livewell, install both ventilators in the single lid and evenly space them out. Again placing the V-T2's directly over the water in your livewell. Be careful to allow needed clearance, so that the throat of the V-T2's will clear the livewell/baitwell frame or any lid lift or lock. It is recommended to make the first few cuts or revolutions with the Bi-metal hole in reverse, and then place drill in forward to cut through the lids. This will keep carpet from threading out, and make a nice clean cut. Place the V-T2's in the holes with the louvers facing bow and stern (front to back). On saltwater boats that have a high bridge, it is recommended to position the V-T2's with louvers facing starboard to port, therefore utilizing cross winds. Then drill holes and attach the V-T2's with the provided #6 size marine fasteners.
Click on image for larger view.
This picture shows the install of the V-T2's on a boat with 2 lids over the livewell.
This picture shows the install of the V-T2's on a boat with a single, large lid over the livewell.
